66Dvert
Working on my custom car parts again!
I thought that out of the 2 darts I could have lucked out and had at least 1 good one to make a mold off of, but no suck luck. so now I'm looking for a non rusted through header seal channel and those 2 side pieces for the early A's so I can get a good mold off of them to cast in resin. here's mine to show what I'm looking for ,(minus the rust holes 
)
here's where it goes on the top mechanism
View attachment !!!where the channel is-goes.jpg
my best one (hey at least it in one piece mostly.)
View attachment DSCF4140.jpg
the left and right side pieces that go with the header seal channel
View attachment 0803121713.jpg
yup it sure is ugly. if I can't find a good one then I'll epoxy the heck out of it and see if I can get a good casting mold that way, but it sure does look bad!
View attachment DSCF4143.jpg
I'm not even going to take a pic of the other one. it's in about 4 different size rust pieces. so this is what I have to work with and want something that doesn't have all the extra rust holes:glasses7:
View attachment DSCF4142.jpg
)here's where it goes on the top mechanism
View attachment !!!where the channel is-goes.jpg
my best one (hey at least it in one piece mostly.)
View attachment DSCF4140.jpg
the left and right side pieces that go with the header seal channel
View attachment 0803121713.jpg
yup it sure is ugly. if I can't find a good one then I'll epoxy the heck out of it and see if I can get a good casting mold that way, but it sure does look bad!
View attachment DSCF4143.jpg
I'm not even going to take a pic of the other one. it's in about 4 different size rust pieces. so this is what I have to work with and want something that doesn't have all the extra rust holes:glasses7:
View attachment DSCF4142.jpg
