hellfirechrome
Well-Known Member
Awesome Eaton blower kit, assembled for my slant six but after mock up found it set too high due to far outboard placement on my Hyper-Pak slant six. Would work better with short runner slant six or any V6/small V8 application.
Includes:
Blower (M90 draw-through)
Custom 4bbl adapters top & bottom
Double-sealed bearings (installed)
Freshening kit (oil and bushing, new in box)
Two carb riser stacks
15 degree adapter for base (squares it up w/engine, most intakes have a reward tilt)
Second longer snout
12x12 1/4” aluminum for fabbing offset riser
Aluminum brazing rods
Two pullies (6 rib and 8 rib) on snouts
$825 OBO. Everything you need to install on your carbureted classic. Long time eBay power seller, will take PayPal goods&svcs to give buyer protection. Add shipping or pickup in Tahoe/Reno. I can also give guidance on installation/set up.
Includes:
Blower (M90 draw-through)
Custom 4bbl adapters top & bottom
Double-sealed bearings (installed)
Freshening kit (oil and bushing, new in box)
Two carb riser stacks
15 degree adapter for base (squares it up w/engine, most intakes have a reward tilt)
Second longer snout
12x12 1/4” aluminum for fabbing offset riser
Aluminum brazing rods
Two pullies (6 rib and 8 rib) on snouts
$825 OBO. Everything you need to install on your carbureted classic. Long time eBay power seller, will take PayPal goods&svcs to give buyer protection. Add shipping or pickup in Tahoe/Reno. I can also give guidance on installation/set up.
