Edelbrock LD4B intake for 66 up 273-318

[az426hemi]

I have an Edelbrock LD4B for sale. There is a helicoil in one of the thermostat bolt holes. And the exhaust crossover has been welded underneath the intake. Check out the photos.

I want $100 for the manifold. I paid $150 for it because the seller didn't point out any of the issues.

Very usable intake.

Mike

 

[RustyRatRod]

That's actually for the 340/360. The D4B was for the 273/318.

 

[rumblefish360]

That intake is in the old Direct connection book for use on the 318.

For the 340, it was the LD340

 

[RustyRatRod]

That intake is in the old Direct connection book for use on the 318.

For the 340, it was the LD340

Ok. I see where my confrooshun was now. The D4B was for the early small port 273 and LD4B was for the later 273 and 318. Thanks for clearin that up. I knew there was a difference.

 

[Commando66]

The D4B is for the 64-65 273 with the different intake bolt angle. Port size is the same on 273's.

 

[rumblefish360]

Well, the D4B is a dead ringer IIRC to the LD4B in looks. That be an easy thing to confuse, no doubt.

 

[RustyRatRod]

Well I had it wrong inside out, upside down and backwards. Thanks fellas.