ENGINE START UP STAND PROJECT

[BLKNBLU340DSTR]

BLKNBLU340DSTR submitted a new Article:

ENGINE START UP STAND PROJECT

View attachment 1715834402 12/10/21- A friend challenged me to do this mopar project, so here goes. I picked up a '69 Mopar 383 HP core and rebuilt it the way it should be, as close to oem as possible throughout, at least for the run test. More on that engine build later as it will go up for...

Read more about this article here...

 

[BLKNBLU340DSTR]

BLKNBLU340DSTR updated ENGINE START UP STAND PROJECT

Still learnin...hang in

View updates to this article...

 

[Steve Cotter]

Very cool! Did you fab the mounting plate for the starter?
Usually, I see people use a bell housing and bolt the stand where the 4 speed mounts.

 

[BLKNBLU340DSTR]

Steve, you can buy a laser cut very precise starter mounting plate, (simulating a bellhousing mount), for most any vintage American made engine from (rumz1) on ebay. 25 bucks.He has them for Mopar Big/Small blocks. Steve
SMALL BLOCK Chyrsler starter plate | eBay