moparstud440
Well-Known Member
My car has fenderwell headers and I'm thinking about adding an exhaust system. Can you guys post some pictures of how you did yours to give me some ideas. Thanks.
Fenderwell header exhaust system
- Thread starter moparstud440
- Start date
-
33IMP
Well-Known Member
There have been posts here with pics of fenderwell systems that were plumbed back under the middle of the car. That's what i would do.
Unfortunately my fenderwell header car is too low, and doesn't have any room in the middle of the car for an exhaust system, so mine just run a magnaflow offset in-center out turbo style, along the rocker panel,,with a turnout in front of the rear tires.
Unfortunately my fenderwell header car is too low, and doesn't have any room in the middle of the car for an exhaust system, so mine just run a magnaflow offset in-center out turbo style, along the rocker panel,,with a turnout in front of the rear tires.
Go with bull horns, Stuff heavy steel wool in them and put removable cross pins in. Easy Peasy. They are not that loud
mopowers
Well-Known Member
Looks great! Do you have any photos of the side of the car from a distance? I'm curious how low the pipes hang where they dip under the subframe connectors.
moparstud440
Well-Known Member
Looks great. Are the 2 bent pieces that go from the header to the straight run with the muffler 45 degree bends?
33IMP
Well-Known Member
That looks great Ted, I wish I had the room to do that with mine. Three inch pipe?
If you look at this thread you can see how I had my 383 Duster with fenderwell headers done
1974 Duster 383 refurbishment | For A Bodies Only Mopar Forum
1974 Duster 383 refurbishment | For A Bodies Only Mopar Forum
33IMP
Well-Known Member
Looks good, Jacko. I wish I had the room under the car to do that.
Thanks, i went with 2.5 inch pipe just to gain a little ground clearance.
-
