FlowTech Headers

[mmiruzzi]

Any experiences with these headers in a '68 Barracuda.
Why are they half the price of identical specs. Hookers????

 

[5258]

I have the ceramic coated flow techs on my 69 Dart small block, No issues with them, installed from the bottom up with the T bars out, did not have to raise the motor. So far no issues. The collector flange could have been thicker is my only complaint.

Mike..

 

[SirDan]

I bought them for my 73 dart. I haven't installed them yet but i do have pictures of the product.

 

[MoparDart68]

Look just like the hedman headers I had. They hung too low and developed lots of dings on the drivers side.

 

[Dartnut]

If you have power steering, be prepared to modify the tube that hits the coupler.
I smashed mine almost flat there and have to take them out and modify the tube.
Manual steering should be o.k.
They do hang a little low.
I had to ding the tubes where they hit the torsion bars, but nothing serious.
All of this is in a '69 Valiant 2 door post with a 318 auto. Stock '69 k member and motor mounts.

 

[stokey04964]

Does the T-Bar go through the header?

 

[duster340]

used to have a set,fit good on my car with powersteering,alitle lowhanging but ok

 

[rumblefish360]

Does the T-Bar go through the header?

No, it does not, BUT, the steering linkage does.

 

[rnaz]

I just picked up a set of ceramic coated Flowtech's off of e-bay for $180 for my '70 Dart.

I'm glad to know that they won't be too much of a problem to install. (Especially since the motor will be out of it this weekend!)