headers for 318
- Thread starter 6t3gt
- Start date
-
joesnow
Well-Known Member
I just finished installing my set on my '65 Barracuda. Fit OK not alot of extra. I would buy again. Oreder ahead of time , he is known to take awhile. Good Luck. PS . All I had to do is lift the motor off the mounts and push it side toside to get them in.
Here is a post from another site. The guy you want to talk to is Harold. I will also include a link with some install pix from another board members car and additional info.
"As was already mentioned, they are designed to work with a manual steering box. He is selling them for $225 COD. You can reach him at 1-479-650-9989. You can also e-mail him at [email protected] ".
http://forabodiesonly.com/mopar/showthread.php?t=2735
Post Extras:
Here is a post from another site. The guy you want to talk to is Harold. I will also include a link with some install pix from another board members car and additional info.
"As was already mentioned, they are designed to work with a manual steering box. He is selling them for $225 COD. You can reach him at 1-479-650-9989. You can also e-mail him at [email protected] ".
http://forabodiesonly.com/mopar/showthread.php?t=2735
Post Extras:
I would install the headers before the engine and grab a couple of buddy's to hold the headers while the engine is being dropped in.
cavemanmoron
Well-Known Member
I would suggest using the 1964-66 Abody
Stock exhaust manifolds.
Works fine with the 318 in my 1964 Signet Valiant.
http://www.youtube.com/watch?v=Ud8mci4rjFU
Stock exhaust manifolds.
Works fine with the 318 in my 1964 Signet Valiant.
http://www.youtube.com/watch?v=Ud8mci4rjFU
camd64
Remember Landy
I would have to say run the Spitfires from Harold. i have heard nothing but good about the fittment and quality. i have a set of the tti's in my 64 and all i can say is god help me if i ever have to remove them. PITFA!
-
