I was wondering if anybody has had this problem before. My hood hinge spring somehow was off the stud when I got the car.(it's the stud sticking off the body and the spring is held on by a star washer).Anyway if somebody knows of an easy fix let me know.Oh yea it's a '72 Duster.
hood hinge problem,help!
- Thread starter cooltx
- Start date
-
doofsduster70
1970 duster 340
i have a 70 duster that the same thing happened to all i did was tack weld the spring to the stud.
Is that toothed washer missing ? If the hindge is bad the spring tension will casue it to flare sideways . It will scar the fender so people set the spring off.
Raise the hood and check the hindge for excessive lateral movement.
No need to reattach the spring if its going to come back off again.
The easiest way to service the hindge is drive the hindge pins out of the door and set it off. You'll need a floor jack with a piece of 2x4 under the door
and a helper. I throw an old towel over a old tire and lay the door on that interior panel up when servicing door or hood hindges. Good luck
Raise the hood and check the hindge for excessive lateral movement.
No need to reattach the spring if its going to come back off again.
The easiest way to service the hindge is drive the hindge pins out of the door and set it off. You'll need a floor jack with a piece of 2x4 under the door
and a helper. I throw an old towel over a old tire and lay the door on that interior panel up when servicing door or hood hindges. Good luck
TROUBLESHOOTER
troubleshooter
Reset the spring, put a flat washer over the stud against the spring and then drill a hole through the stud for a roll pin.
green1
Well-Known Member
Napa has the star washer.
-
