How to Rebuild a Small Block Part 2: Cam Bearing Install

[krazykuda]

krazykuda submitted a new Article:

How to Rebuild a Small Block Part 2: Cam Bearing Install

In this chapter I am going to go through installing the cam bearings in the block... If you don't have the tools or experience to do this at home, then have a qualified machine shop do it for you, but make sure to check the bearings are installed properly by probing the holes with a...

Read more about this article here...

 

[Scampi]

I like the coat hanger trick. Also doing practice installs with the old bearings is smart too. You have to be careful with the cam bearing tool. It will nick the cam bearing on the driven side if the rubber part of the tool hasn't expanded fully into the cam bearing.
Thanks for sharing this information.