Inertia Motorsports

-
mopar340dave

mopar340dave

Well-Known Member
Joined
Jan 11, 2009
Messages
1,390
Reaction score
4
Location
Florida

Will Inertia's cams work in my Concorde????


I have a 2000 Concorde LXi with the 3.2 in it. The 3.2/3.5 OHC engines are in the same engine family.
Inertia Motorsports sells cams for the 3.5 Magnum in the later model rear wheel drive cars. If it's the same engine, I'm thinking the cams would be a cool upgrade for my Concorde LXi!

Have any of you played with the mopar 3.2/3.5's in the intrepid/concorde/300m or the newer magnum/300?

http://www.allpar.com/mopar/33.html
http://www.inertiamotorsports.com/camshafts.html

I had this posted with a different title but did not get any replies.:read2:
 
With all respect, we're on a CLASSIC Mopar site. It says that on the main forum page. Good luck with it, though.
 
Yep, I understand they're a sponsor. I hope it works for them on a site that discusses old cars.
I think a response about a lawnmower in the General Discussion forum is appropriate. ...Jeez, searching my posts!
Sorry I offended you. I understood that could happpen when I posted. I didn't mean to and I should've minded my own biz.
 
lol, I probably wouldn't have if you had not done the same thing on another thread I was bsing on...."show us what pressurizes your mopar".....
I'm guessing they ad on our site because they know that a lot of us don't just customize are old stuff, but everything we drive.
no biggie...I'm gonna give em a call.

I was just::poke:

PS You realize that this thread is also in the general discussion section, right?
 
Inertia does not know if the cams are the same between the fwd 3.2/3.5 and the later 3.5 rear wheel drive.
 
Well, they are a dealer that specializes in the late model rear wheel drive cars~~~charger/300/magnum/challenger

He did not wanna say it would fit when he did not know for sure.
I did a little research and it does appear that they (the early 3.2/3.5 and the later 3.5/4.0) are the same engine.

http://en.wikipedia.org/wiki/Chrysler_SOHC_V6_engine
 
abodyjoe said:
they sell the stuff and can't tell you if it fits?? don't think i would be buying anything from them..
Click to expand...

Relax Joe... Stu the owner of Inertia knows his stuff.... However this member asked if a cam from a car that Stu sells parts for (3.5L charger, mag, 300) will fit in a car he doesnt even advertise for.

I have purchased thousands of dollars worth of parts from Stu and they have all been topnotch. He built be a 5.7y based stroker that is still currently the fastest 5.7 based stroker in the country.

I think its asking a lil too much to expect a guy to know about preformance parts that he doesnt sell.


Jason
 
I agree...both of my late models are sometimes hard to buy for...especially the 2000 Chrysler LXi w/3.2L SOHC. It turns out it is the same engine (family). Same 81mm stroke x 4mm narrower bore (92 vs 96).
Look at the chart down towards the bottom of this page titled: Chrysler V6 engine specifications - “LH” series, 1998-2007
http://www.allpar.com/mopar/new6.html
 
You must log in or register to reply here.
-

Back
Top