Just dropped 850 on TTIs

[mbaird]

Ouch ! Kept putting it off but finally had to pull the trigger.

1 7/8 W2 Race headers with 3.5 collectors.

TTI is one of the only games in town for W2s. Sure hope they fit well.

 

[72Dart6pack]

My TTI shortys. Yes they sell them in black. Don't think it's listed thou?

 

[mbaird]

I actually wanted black but it cost another 100$ and I was already sweating.

 

[72Dart6pack]

They are works of art. I was happy. Yes! Not cheap.

 

[dadodgekid]

Mine fit awesome, just had to ding the tube on the passenger side where it comes down by the oil pan... but that could have been my pan casuing the issue.

 

[rumblefish360]

Ouch ! Kept putting it off but finally had to pull the trigger.

1 7/8 W2 Race headers with 3.5 collectors.

TTI is one of the only games in town for W2s. Sure hope they fit well.

The “Other manufacturers” may not route the tubes in the same manor and are more of a “race” header over the street strip TTI’s. And they cost a good bit more.

 

[n.y.340 dart]

Have a set on my w2 sb,used the engine lift and between moveing the motor and headers they went in nice. Very close fit but they went in. No dings!

 

[mbaird]

Everything will go in from the bottom as one assembly on this car.

 

[n.y.340 dart]

That’s even better, good luck with your install.

 

[Marcohotrod]

Tubular Automotive, Rockland Mass. makes w2 headers

 

[mbaird]

I used them for my last W2 motor and checked them out this time as well but you have to relocate the brake distribution block .

 

[MOPAROFFICIAL]

I actually wanted black but it cost another 100$ and I was already sweating.

I bought then raw and sprayed'em with a can of black header paint. Used a zillion vinyl gloves to keep then clean.