Just got my FlowTech headers

-
briankaplan

briankaplan

greenduster
Joined
May 30, 2005
Messages
3,348
Reaction score
118
Location
northern wi.- rhinelander
Got them at the shop today. Opened them up. They look just like
the Hookers that are on the Duster now.
I eye balled them just to see how the looked. The top ends, by
the heads have the same contours. This almost looks like a
straight bolt in to me. That will be good. Hope the collector
ends are close. Then no problems with the rest of the exhaust.
Wish me luck. But then I have all winter to get-er-done.
 
i installed flowtechs on mine when i did the engine swap, they cleared everything but sat a little low, not horrible though. Overall i was very pleased with them
 
Yeah. There coated. Almost look like chrome.
My boss thought they were chromed.
It's time for a new set. They are so rusty,
I don't know what's holding them together.
Think I've been losing points at shows because
of them. They sure look pretty.
 
when i swaped my 1 5/8" hooker supercomps (#5116 if i remember right) for some flowtechs i found that the colectors where about 3" shorter, ended up building a whole new exhaust that time but it could have been adapted easily at a muffler shop or att home with the right tools:)
 
i got that feeling too! Drove through Talmadge yesterday and stopped at Summit and got my new dougs headers (ceramic coated) and pypes exhaust (409 stainless steel). and they are all "test fit" on my living room floor right now.
 
You must log in or register to reply here.
-

Back
Top