kelsey hayes disc brake rotor swap

[Slantsix64]

Hey guys its time for me to replace rotors and pads on a small bolt disc brakes. The last time i had to bang out the studs to replace and mount the rotors to the hub.

This time im wondering can i just cut the swedge with a 5/8 hole saw and swap the rotor on that way?

 

[RustyRatRod]

Hey guys its time for me to replace rotors and pads on a small bolt disc brakes. The last time i had to bang out the studs to replace and mount the rotors to the hub.

This time im wondering can i just cut the swedge with a 5/8 hole saw and swap the rotor on that way?

I've never seen rotors swedged on in my life and I've been doing this since 1974.

 

[Slantsix64]

I've never seen rotors swedged on in my life and I've been doing this since 1974.

lol well mine were with the original rotors on the hubs, its been a while i just remember i had to bang out the studs in order to get the original rotor off the hubs.

 

[Kendog 170]

I just press them off and on so I don't damage the studs.

 

[66fs]

If you have done it once you should be good. You didn't swedge them again did you? Should just be a easy press out now.

 

[68 CUDA FORMULA S]

Press out the wheel studs change the rotors and then press them back in again, make sure you clean off the hub surface. I did my 68 SBP rotors a little while ago but I decided to replace all the wheel studs. No swedge.