Let's see your homemade K-frame engine/trans/suspension cradles...

[ocdart]

...for small block pad mounts and 727 transmissions.
The first time I posted this I put a lame title on the thread.

We're going to be pulling the engine/tranny from my '69 Dart in a few weeks and I'm planning to pull it from under the car complete with K-member and front suspension. I'd like to be able to re-assemble everything on a cradle and then roll it back under the car.
The cradle would then be available to everyone in my Inland Mopars club to use whenever they may need it.
Any pics and dimensions, info or assistance is greatly appreciated!

Thanks in advance...

 

[va58]

this is not quite what you are talking about, but this is a k-member jig on an engine stand. Just to support at working level.

 

[va58]

this is one i pulled from a member here because i liked it's design. Don't remember who so unable to give credit to the owner/builder.