Mopar 360 parts

-
Status
Not open for further replies.
440BelII

440BelII

Well-Known Member
Joined
Apr 26, 2008
Messages
1,120
Reaction score
120
Location
Darien Center, New York
Rating - 90.9%
10   1   0
Contact seller
I have sold my cars off for the time being to get some work on the house done,so, I'm garage cleaning. Here's what I have up for grabs;I have a complete rotating assembly for a 360;Eagle 3.58 cast crank,Eagle "SIR" I beam connecting rods,Speed Pro 8KH116P piston and ring kit, and a B&M #10236 flexplate. This setup has already been balanced , is brand new(except for the flexplate), and has never been installed.I have $500 invested and that's what I'm looking for out of it all, plus shipping. Pistons are .030 oversize. I prefer to sell it complete ,unless it all gets accounted for, then I will break it up.I also have a set of KB 107 pistons,.020 oversize, brand new, never installed. I would like $125 plus shipping.Also, a small block Mopar Performance distributor,$50 plus shipping,Schumacher /6 to small block mounts,$75 plus shipping(brand new in the box).Lunati Bracket Master II cam. It was run for 500 miles,no problems. $50 shipped. Also a pair of 360 J heads, came off running motor,202 valves, no problems,$200. Sorry for the novel. PM me for e mail or phone # if you have any interest in any thing. I'm open to reasonable offers on this stuff also.
 
Dipstick/tube for a 360 ?

I will take Schumacher /6 to small block mounts,$75 plus shipping (brand new in the box).Please confirm that they are for a 360 that is older than a 72 ?

Need shipping costs and how you want me to pay for it.

Thanks
ian.
 
Negative on the dipstick tube. The mounts are for '67-'72 273/318 on a slant 6 K. Sorry, my fault. I should have listed more info.Although, the instructions show mounting for 340/360. I will do some research and post the results. These came with a project car so I don't have the info in front of me. Don't want to sell you something you can't use.
 
Thank-you..if they can be used for a 360, please put me first in line. :)

My addy is Nova Scotia B0P 1T0 and I really like USPS.

MANY thanks for your legwork.

ian.
 
According to the Schumacher web site, it looks like the 273/318 and the 340/360 mounts are different(different part numbers). I can't say what's different, so I would have to say that they won't work for you.
 
Can you tell me where the piston winds up as far as deck height with either set of pistons? And are they flat top or dish? How much for each set? Thanks
 
Not sure on the deck height. The pistons are brand new and were never installed. Both sets are flat tops with reliefs. $125 shipped for the KB's and $175 shipped for the Speed Pro's.
 
Heads, crank, flexplate,rods, and distributor are sold. Still have the cam and both sets of pistons.Make an offer on the motor mounts if you can use them.
 
Status
Not open for further replies.
-

Back
Top