Need a measurement

[mshred]

center of each hole on the rod that connects from the clutch pedal to the z bar....the holes on my rod are elongated so im going to fill them up with weld and redrill them, but i need to know the length from center to center of each hole...if anyone can measure this for me i would appreciate it.

thanks!

 

[memike]

I am sure my 66 /6 is different mshred, there will be some one here for you soon I am sure.

 

[mshred]

hey memike, im in no rush...whenever someone gets the chance to chime in i would appreciate it

 

[mshred]

would there be a difference in big block to small block as well? if there is, i would need the measurement for a small block one

 

[pntastar69]

Not the exact measurement but it'll get ya close.

http://www.brewersperformance.com/proddetail.asp?prod=CPR147

 

[mshred]

hey pntastar69, thanks for that link...i have seen it before and didnt even notice the ruler beside it...ill show my dad the picture since hes going to be the one helping me with this little resto modification thingie....if anyone else has the specific measurement that would be great, but this helps too...thanks!