Needing long tube header for /6

-
Status
Not open for further replies.
R

renrob5000

Artificial Life Form
Joined
Apr 27, 2007
Messages
16
Reaction score
0
Location
Sherman, TX
Rating - 0%
0   0   0
Contact seller
Looking for a header for my Scamp slant six. Hooker, Direct Connection, other.
Thought I had one but emails aren't getting an answer....so.... :coffee2: :coffee2: :coffee2:
 
i don`t know that one and i can`t believe i`m recommending JCWhitney, but i was reading at another site...All Par (i think) and somebody said JCWhitney has Offenhouser 4 barrel intake manifolds for slant 6 mopars. i went and looked...couldn`t believe it, sure enough they do and they are about $98.00 plus shipping!!!
i have been undecided what to do about my Dart. i am still not sure i`m souping up my 6, but with a manifold at that price it is tempting!
i did check and saw no listings for /6 headers, but who knows...if u call they might have some!
i definitely recommend reading the engine section at All Par ...very interesting information there about ALL the mopar engines!!!
i`m considering changing to a later model V6 or even a 4 cylinder. the problem is finding a rear wheel drive trans for most of them. there might be an easy answer, but i don`t know what it is yet. maybe mitsubishi?
i`d like to keep it all Mopar, but who knows (i know its sacrilige to even think, but) i might put a toyota under the hood!!!
i want small, lightweight, cheap, dependable and gas mileage...i`m not trying to support oil companies or win races! to that end i might use some fiberglass and add a rollcage. could probly shave 500 lbs off the car all totalled? then maybe a 4 cyl/auto would move it decently nd get fair MPG.
ok, i got way off your thread here! haha
 
Guess I might have to get a J.C.Whitney catalog....haven't looked @ one in years. I do have that manifold....got it @ a swap meet. Going to use a Holley 390 that I had for another project years ago. If you're looking for fiberglass go here....I'm considering the bumpers....http://up22.com/duster70.htm
 
Think I have what your looking for. Gotta get me digi cam back... I'll post a pic for ya.
 
Eric_S68 said:
Think I have what your looking for. Gotta get me digi cam back... I'll post a pic for ya.
Click to expand...

Ok I got ... The Headders , I think your looking for. I also have a Offy 4 bbl intake w/a 390 CFM Holley vac sec (needs rebuild from age only, just sittin). I still havent gotten my camera back. Be patient I'll get a pic. $500 for the Headers, intake and Practically new carb. (about 2 gal of gas ran thru it)

I'll Keep ya updated

Eric
 
Sure wish I had found this site when I first started this project. Certainly appreciate everyone's help. Eric....sent you a private message on what's going on. Will be spending tomorrow chasing down an electrical gremlin while planning away on what's next. :salut:
 
Status
Not open for further replies.
-

Back
Top