New bullet for the Demon

-
Demonracer

Demonracer

71 Demon 00 Ram 16 Chrysler 300S 05 Caravan
FABO Gold Member
Joined
Jan 31, 2010
Messages
7,476
Reaction score
6,305
Location
Cleveland, Texas
Here are some pics of the freshly built bullet for the Demon. I just need to get 5 friction clutches for the tranny and it will be ready to install. Sorry for the crappy pics, I took them with my phone.

Bill S.
 

Attachments

  • IMG00014.jpg
    57.5 KB · Views: 453
  • IMG00016.jpg
    52.2 KB · Views: 444
It's a 77 360 bored .060 with a set of .020 over 340 flat top pistons with J heads. Milodon pan, windage tray, and pickup with a HV oil pump. Installed a 20-602-4 Comp cam and lifters with Mancini 5/16 push rods and 273 adj rockers. The top is an Eddy TM5 with a 750 Holley carb. I can't wait to get it in and fired, so I can finally go play.

Bill S.
 
Very nice. What fun you will have with that sucker. Got any pics of the car it is going in? Play nice with the other kids on the block. HAHAHA
 
Check my profile and there are some early pics of the car. As soon as I start installing the new motor and trans, I'll get some new pics.

Bill S.
 
Naw, no porting as of yet. I'm trying to work a deal with a buddy who has a set of X heads, fully port matched both intake and exhaust, with 2.02 & 1.60 one piece stainless valves. I'm slowly wearing him down. LOL.

Bill S.
 
OK, I need some advice from the LA motor gurus. The oil dipstick tube was broken off in my block. I got the piece out, but am having a tough time getting the new tube in. Any words of advice?

Thanks,

Bill S.
 
I went to one of those pricey milodon stainless braided tubes, it installed easy and doesn't leak. The original style was a pain to install, IMHO.
 
Bob,

You were reading my mind, or I was reading yours. LOL That is exactly what I did this morning, and "voila" it went right in.

Thanks,

Bill S.
 
You must log in or register to reply here.
-

Back
Top