New Quick Performance Axles

-

512Stroker

We are all here because we are not all there.
Joined
May 30, 2016
Messages
3,493
Reaction score
2,929
Location
Freedom, MO
Installed a set of new Quick Performance axles today in the 8 3/4 rear end in my 67 Barracuda.
I ordered these with new Green bearings and lugs installed, 30 spline, stock length.
Slipped right in installation was normal other than a couple lugs on one axle was slightly out of alignment and needed adjustment. Appears to be a quality product and was shipped in short order. I would order again.
Old axles out, new axles prepped and installed

axles 2.jpg


axles 1.jpg


axle 3.jpg
 
Nice,what did they run you? Have you got a web address?
 
Jim are these big bolt pattern ? and if so what do you have to do for brakes and drums?
 
Jim are these big bolt pattern ? and if so what do you have to do for brakes and drums?
Al, my axles are 4 on 5 but you can get the big pattern - no problem just tell them what you are after.
For sure you will need a different brake set up off a B body
Edit - Sorry should be 5 on 4 bolt pattern
 
Last edited:
I went with the Yukon ...it allowed me to use stock small bolt drums...just had to redrill 4.5 pattern and open center register a bit....
 
Jim are these big bolt pattern ? and if so what do you have to do for brakes and drums?

if switching to large bolt i find the best way to go is just get a drum set up off anything with large bolt pattern. bolt on deal.. i have 11x21/2 i think it is drums off of a big c-body on our dart. you can re drill the small bolt drums but you'll have to specify you are doing that when ordering the new axles.
 
Last edited:
Thanks. Doctor Diff hasn’t had them on there site in a while. EZ ordering from these guys?
results may vary but I ordered some brake stuff from them and the ordering process was a breeze, their shipping time was longer than I appreciated, the product was good quality
 
Thanks. Doctor Diff hasn’t had them on there site in a while. EZ ordering from these guys?

Due to supply chain problems, I have been out of 30 spline 8.75 axle shafts for several months.

In the mean time, I have been drop-shipping custom axles made to my specs from Quick Performance.
 
Due to supply chain problems, I have been out of 30 spline 8.75 axle shafts for several months.

In the mean time, I have been drop-shipping custom axles made to my specs from Quick Performance.
So... can I order up a set from you and you can get it done then?
 
-
Back
Top