Painted my car and some bubbles developed on the rear wheel well lips. I sanded this area to the factory primer and went from there.well a year later and I have rust bubbles. A few spots have rusted through( about the size of of two pencil leads side by side is the biggest). How should I go about this? Not big or bad enough to cut out and I can't get to the back side from inside the car. Thought about taking a syringe and squirting phosphos into the pin holes and the back side of the panels the best I can and then the same with Por-15. Any suggestions?
Rear Wheel well lip rust, need suggestions
- Thread starter lee g
- Start date
-
FISHBREATH
Well-Known Member
- Joined
- May 21, 2008
- Messages
- 21,384
- Reaction score
- 73
Some pics would help.
However, if there are rust pinholes, you can be assured that the remaining metal in the area has been rusted thin...from the inside.
However, if there are rust pinholes, you can be assured that the remaining metal in the area has been rusted thin...from the inside.
-
