Removal and reinserting terminals in harness block

[Val 73 JB]

What is the best way to remove and reinsert terminals in a Block < electrical connectors?
What would you recommend?
Honest I tried looking this up on here but everything referenced (Engine Swap) and so on *(I get it too with the use of the word (Block)... What's a better way to phrase this?

 

[rklein383]

If you are referring to standard Packard terminals, I have had good luck with using needle nose pliers and gently squeezing the the terminal close to the base and gently pushing the blade.

 

[kdbunn]

Not sure if you mean this, but to remove a connector from this type....

You need to insert a small blade screwdriver into the little slot slot above the the terminal like this...

The idea is to push the little tab down that you see in this pic, then pull the terminal out. Sometimes it take a little wiggling to get it loose. Sorry for the crappy focus.

 

[RustyRatRod]

You need a set of terminal removal tools. That is, unless you want to eff it up.

 

[Car Nut]