[FOR SALE] Slip Yoke Driveshaft For Early Valiant/Barracuda

-
Status
Not open for further replies.
whitepunkonnitro

whitepunkonnitro

Well-Known Member
Joined
Dec 6, 2011
Messages
14,798
Reaction score
890
Location
Murfreesboro Tn
Rating - 98.2%
162   3   0
Contact seller
This is a nice, straight shaft from a 66 Valiant 273/Auto car. 49.5 inch center to center with a very long yoke. It looks like it could be used with a 8.75 in one of these cars by swapping to a shorter yoke from a later car...do your homework on that one.
If you're wanting to get away from the ball and trunion set-up on your 63-65 car, this is the ticket. Asking $100 plus the ride. PM me if interested. Thanks FABO!
 
The yoke is for a 904. This is a stock 1966 Valiant shaft, and there were no 727's installed in those cars. If the center-to-center length is good for your application, you can always swap over to a 727 yoke.
 
Are these the 2 piece driveshaft with the rubber insulator sleeve at the tail end? Or are they a one piece shaft? Thanks, Geof
 
Status
Not open for further replies.
-

Back
Top