[SOLD] Small block edelbrock complete top end package for sale

[Chris compson]

Small block edelbrock performer rpm heads, complete, with 1.6 Harland sharp roller rockers with hughes stud hold down kit, victor 340 intake ported with a 4150 to 4500 adaptor plate, heads were ported and milled my Ryan at shady dell speed shop, flow 289 at .600 and milled .060, 5 angle race valve job,also comes with fabed valve covers in pick and arp head stud kit, this combo went the best of 9.79 at 139 in my stock stroke 360, $2800 for everything!! I have double that in it, also got a pair of custom made racetech pop up pistons for sale for $500 for a stock stroke 360 made for the closed chamber heads,

 

[19DUSTER73]

Any pics of the pistons? Bore size?

 

[Chris compson]

Any pics of the pistons? Bore size?

Any pics of the pistons? Bore size?

unfortunately the only picks I had were on my old phone that got wet and wont turn back on, I have the entire spec sheet on them, I could send you a picture of it, they are 30 over 13.6:1, I had about 230 cylinder pressure when I checked all cylinders this spring, I only have a season and a half on them, I going with a w9 set up so all this stuff needs to go. Thanks!

 

[19DUSTER73]

I'll have to pass. That 360 rips! Good luck with your sale.

 

[7e5hangten360]

pm sent

 

[7e5hangten360]

pm sent

very interested . was epoxy used for porting the heads? how about shipping cost to postal code j3a-1v4, st-jean sur richelieu, quebec, canada? i would take everything but the pistons.