Quick back story: I bought these for a race motor in 2002, dropped them at the porters with a deposit for full port and polish. 15 months later I picked them up with 1 intake port mostly done. In 2006 I bought another head at summit, cleaned up the flashing only, had a fresh valve job done, and put them on my station wagon with a heavily milled RPM intake. The intake never sealed and it sucked oil out the galley. It fouled three sets of plugs in 4 months, so I changed the whole motor for a fresh 440. I just found I dragster guy up the road with a twin dominator tunnel ram, and I can't afford it. So I looked around the shop, grabbed this top end, sent the heads to the water-jet, glass beaded the valves, and took some pics. I do not have springs. The intake is max wedge size(factory), the heads are not. 4150 flange. Hughes valley pan, Mopar porting templates, spacer plates, locks and retainers. The intake fits RB block with these heads. If these were going on a street car , I would have total confidence lapping the valves in and bolting them on. Sorry, no trades no PayPal on this one. He wants cash, so do I. Please feel free to ask any questions. My phone number is 330-386-3688 I'ill take postal money order, cashier's or personal check. And I will drive up to an hour and a half to meet a serious buyer. $1600 firm thank you
Last edited by a moderator:
