Timing question

[71valiant]

I was wondering what exactly I need my timing to be set at. I have an all MSD setup. 318, edelbrock performer, 3000 stall. Comp cams xtreme energy cam 20-223-3. gross valve lift .480 tappet lift 280 lobe sep. 110. I was at the track last week and it was acting strange. I had it set at 36 degrees. All the guys I work with drive ford and chevy. I ask them but there like "man I really don't know what kind of timing chryslers time good at. My 350" :roll: ..... etc etc etc. I'm sure you know what I mean. I read on here to not use an advance timing light? What do I need to run the rpms up to, to set the timing? This is a part of automoblies I'm not too keen on, so bare with me. ops: If you guys could help me out it would be greatly appreciated. :thumleft:

 

[onehellofadart]

You can use a digital advance timing light.
As for timing I would start with 17* initial, and 34 total
all in by 2200-2500rpm.(If you used the light weight springs)
Don't worry too much about initial as long as there is
no problem starting the motor easily.

http://store.summitracing.com/defau...10&Ntk=KeywordSearch&Ntt=timing+light
< Equus < Equus Products Timing Lights < EQU-3568

 

[abodyjoe]

i usually set a small block at 35* total and + or - from there...

 

[340duster]

I usually shoot for 34-36 total and then rework the distributor advance slots to obtain 15-20 initial.