torque on 904

[martin53]

How much do I torque the bolts on a 904 transmission pan. I'm using a rubber seal.

 

[krazykuda]

I would not torque them.


Just snug them until you see the gasket just start to squeeze out, then stop. then go around to each one after the last to double check and make sure that they didn't relax while tightening the others...

Every time that I tried to torque them, I ended up splitting the gasket....

 

[martin53]

The instructions that came with it says to torque 120 I've never use a rubber seal that's all they had at auto zone and I didn't wait for cork seal

 

[tekslk]

I would just tighten them down but you dont want that much that your bending the pan, Or if all else fails follow there instructions They had a reason for printing them.

 

[Woods74]

Snug and a kiss.

 

[KENTON]

150 inch pounds.