[WANTED] Trim rings for 15 and 14 inch rally wheels

[1973duster340]

I was looking to buy a set of trim rings for my duster but they only sell them in sets and i have 15 inch on the rear and 14 inch up front. Looking for some in very good condition. I am located in southern california. Thanks

Jeremy

 

[1973duster340]

These must be a hard item to come by. I was trying to avoid having to buy new 14' and 15' inch sets and selling 2 of each. I wish these were available individually.

 

[1973duster340]

Should i just buy some after market trim rings? I was thinking this would be an easy item to come by on this forum but doesnt seem like it.

 

[limegreen70]

I have some 14s but the are rather beat up did you try Coker?

https://www.cokertire.com/oem-trim-ring-3157.html

 

[Dusterndart340]

I might have a couple new 15" Wheel Viniques in the attic; if so I will let you know-

 

[toolmanmike]

If you want some nice trim rings buying new might be the best bet. I bought a set of 4 new ones at the Nats for $100. Just a suggestion. tmm

 

[FJRdoc]

I bought a pair of 15x6 inch trim rings from Coker at Chryslers at Carlisle. I believe that I paid less than $80 for two with the show discount. They're not an exact match of original 15 inch trim rings but I just couldn't justify spending crazy money on used trim rings that looked like they were run over by a lawn mower.
I polished the outer edge of the ring to match my 1970 14 inch rings up front. In retrospect, it probably would have been easier to by a polished ring and apply the brushed finish to the inner surface.

 

[1973duster340]

If you want some nice trim rings buying new might be the best bet. I bought a set of 4 new ones at the Nats for $100. Just a suggestion. tmm

I would buy a new set but i have 14 inch up front and 15 inch in back. Not a fan of how the ones from Coker look and the others i have seen are sold in sets of 4.