u-joints for 9" ford, please say yes
- Thread starter Wilnutt
- Start date
-
dusterdon
Well-Known Member
The drive shaft will probably have to be shortened. When this is being done, have the driveshaft shop put a ford compatible end on the drive shaft. Its no big deal.
don
don
OUTLAW
Master of All Mopars
Last time I had something similar done it was about $75 plus the flange and joint (including balancing)
DBrown
hold my beer...
WAIT!
there was 2 different joints used on 9"s that I have seen but no matter, you can get a conversion joint! take both joints into the parts house and tell them what you are doing...they will get a few off the shelf and make it work.
also, I measured a little and I don't think it is going to be too far off...I am preping for my swap next week.
there was 2 different joints used on 9"s that I have seen but no matter, you can get a conversion joint! take both joints into the parts house and tell them what you are doing...they will get a few off the shelf and make it work.
also, I measured a little and I don't think it is going to be too far off...I am preping for my swap next week.
-
