MODTOP-Billy
Active Member
HEY, I need some help,
Anyone got a photo of the conv trunk divider panel?
Mine is a 68 Barracuda it has never had one since I have owned it.
Darts should be close if not the same.
I will have to fab me one up. A picture would help a lot.
I assume it hung over the 2 clips that the seat goes on and goes down to the floor.
It will be a little stubby guy 10-12" high 42-44" long. Hard board? black?
I am thinking there had to be something there between the trunk and back seat on the conv?
I have been looking at the back of the seat springs in the trunk for 30 years now.
I have seen other conv back seat pictures here on this site that also have exposed springs.
Should I cover the back of the seat with? Burlap? Leave it exposed springs?
I got all my interior tore out and dug me a big deep hole here.
But now it the time to fix it and make it as right as I can.
Thanks in advance for any help
BB
Anyone got a photo of the conv trunk divider panel?
Mine is a 68 Barracuda it has never had one since I have owned it.
Darts should be close if not the same.
I will have to fab me one up. A picture would help a lot.
I assume it hung over the 2 clips that the seat goes on and goes down to the floor.
It will be a little stubby guy 10-12" high 42-44" long. Hard board? black?
I am thinking there had to be something there between the trunk and back seat on the conv?
I have been looking at the back of the seat springs in the trunk for 30 years now.
I have seen other conv back seat pictures here on this site that also have exposed springs.
Should I cover the back of the seat with? Burlap? Leave it exposed springs?
I got all my interior tore out and dug me a big deep hole here.
But now it the time to fix it and make it as right as I can.
Thanks in advance for any help
BB