You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser.
-
This is my method for honing cylinders with a ball hone, otherwise known as a dingleberry hone. This procedure is only recommended for cylinders...
-
Here are a couple of videos showing the method I use to remove and then mount a tire by hand. Always use care when handling tires. It's not...
-
1) install the floating roller into the long slot of the window mount. I should mention that in the picture the roller is upside down the black...
-
Forgot I had this older chart on ignitions. Basically walks you through any issues you will have. I have always thought this was very helpful...
-
I get asked quite a lot if I have points. A lot of descriptions say just 340, 360, 400, 440 etc. and misleading for sure. Here is a picture so...
-
OK my 64 cuda Defroster
hose is in bad shape. Fixed it on the cheap without wrapping tape around it. Car wrap, just need to find flat black...
-
I recently replaced the engine mounts on my Slant Six and learned a few things the hard way.
The old rubber was worn. So I ordered new inserts...
-
I got new seal and it was good 1/4" smaller than the gas tube and fairly thick rubber. Also awkward to hold tube and press on seal
I went to...
-
Man I wish I knew about stich weld I threw a bunch of big $$$ motors out, easy also just takes a few hours.
Drill the ends of the cracks first...
-
Some of our restoration costs are not within our budgets, but will work for driver quality cars. So, we need to get creative. Here are a few ideas...
-
The goal here is to convert your front clutch assembly from 1 single spring return for clutch engagement to a smoother, more solid multi-spring...
-
Here is my way of restoring cracked 69 barracuda plastic grille surrounds.
Source for the JB Weld Bonding Agent: Lowes or Home Depot. Around...
-
I just happened to stumbbled across this thought I would share it. I have seen this asked for many times on here and also FBBO. I know many times...
-
How to install reproduction headlight adjusters into a front fender
Compare Reproductions to OE (Other than color they look good, bought from...
-
I am writing this because I couldn't find any really clear instructions on how to reinstall the windows in my car. I read lots of article's and...
-
In this chapter I am going to go through installing the pistons in the block... In the last chapter I showed you how to install the rings on the...
-
This is a bit more detailed than other posts about installing a carpet.
Part of installing a carpet is making the holes in the carpet for seat...
-
In this chapter I am going to go through installing the rings on the pistons...
This is the next step to continue after Sections 1 - 5... If you...
