66Dvert
Working on my custom car parts again!
I am working slowly on my wife's and my 66 dart convertible and needed these pieces for an original looking part for the wife's car. (mine is customized and doesn't matter too much) I ordered a piece that was supposed to be for that area in the rear panel "top trim inner panel cover" ....it was UGLY and didn't look like the original at all soooooo. I'm making it .
here is the part I'm speaking about. it's a cast piece and doesn't look good at all
here is the design for the new piece
next making it real....well at least what it should fit over anyway
dang the parts actually fit! woooohooo go me!
had a little webbing I need to address but it looks like it'll make some usable parts after I do the needed spacing and adding the 5 degrees draft I forgot to add(DUH!).
now I have to figure out how to cut it out on the homebuilt CNC..
here is the part I'm speaking about. it's a cast piece and doesn't look good at all
here is the design for the new piece
next making it real....well at least what it should fit over anyway
dang the parts actually fit! woooohooo go me!
had a little webbing I need to address but it looks like it'll make some usable parts after I do the needed spacing and adding the 5 degrees draft I forgot to add(DUH!).
now I have to figure out how to cut it out on the homebuilt CNC..