a quick & dirty check if your alternator is working take the blade of a pocket knife and hold it near the back of the alt. where the shaft is and you will feel a magnetic pull if the alt. is putting out. could this magnitise the pulley ? I do not know
I don't know if you have a exhaust cross over on your intake manifold,but I have had a couple 318's that were running bad and the exhaust cross over was completely clogged with carbon,cleaned them out and they ran good.
I had a car once where the lower hose had a bubble in the internal lining that was restricting flow and overheating,it looked and felt normal on the outside.
I put a autometer speedometer in my dart.I do not have the instructions in front of me but on mine you press the odometer reset to get it in the calibration mode at a mile marker then drive 2 miles to a mile marker stop and press it again. it was counting the pulses from the sender during the...
I did a slave mount like sweaty betty on my Dart . It has 2" fenderwell headers
so I didnt want the master on the firewall because of the heat and I did not
want to mount the master at a down ward angle. what I did was mount the
master to the inner frame rail directly across from the...