Recent content by Claudius

I have decided to convert to modern bucket seats for safety and comfort reasons. I am asking $500 for this front bench seat, plus applicable shipping. Pickup in the Greensboro, NC area is preferred if you are close enough. The seat is both large and heavy, making packing and shipping rather...

Yes, 67Dart273, that was exactly the problem. Everything runs now. Thanks!!

When the rebuilt engine was put into my '68 Barracuda, the original harness was still in place and it was adapted by the mechanic to work with the MSD 6425 CD ignition box. I carefully removed the front and under dash harnesses as part of a complete replacement of the car's wiring. The kit I...

I used a Summit Racing 850027 distributor with a MSD 6AL (#6425) in the 318 block used to build my 392 stroker. The MSD distributors are much more expensive so I am happy with my decision. FYI, I originally had acquired a MSD Stacker 7000 box long before getting the distributor but that was a...

I chose to fabricate anchors as per the photo below. The dimensions of the plate allow for insertion into the large hole and then 90 degree rotation. Fabrication steps: 1) The hole drilled through the plate must be 1/2" to accommodate the non-threaded part of a seat belt anchor bolt. 2) The...

Thanks for the input guys!

I looked through this post and those linked to it. The photos are great but I am still at a loss as to where to install the shoulder belt top mounts in my 1968 Barracuda notchback. The photo below does not match any of what I have seen here. The front and rear window interface is clearly...

Well, the two brackets finally arrived and they fit! They did match correctly with the dimpled marks in the floor, just as per abodyjoe's thread. The image I had originally posted for the 81344 was not correct but the one for the 81345 was correct. In fact, each is a mirror of the other in...

Thanks for adding this link. It will help everyone following this post. I am still waiting for the new seat brackets as they were back-ordered at Procar. I will post images once I have the brackets.

I will be getting a set of the non-upholstered Pro90 1300 series and getting them custom covered. I found a source of very nice vinyl that matches the original colour of the back seat.

I need one of each. The 81344 is for the driver's side. The 81345 is for the passenger side. If you look at the text I had put in the original pictures, I note which one is used.

One of the parts is not going to be shipped from Procar for at least 3 weeks due to lack of inventory. However, here are images of the two brackets that should serve as optimal replacements. I will try to remember your request. If you have not seen them in a month, please ping me privately as...

I jumped on a chance to buy the Procar seat brackets for my 1968 Barracuda because JEGS had them for a good sale price. The 81340 and 81341 are listed as the suitable Procar part numbers for this model year ('65 - '69 inclusive). When they arrived, I checked the fitment and was surprised. The...

Ditto for the top half of the rear seat...

Since this is a public forum, I will share an image I got from the Detroit Muscle web site. The picture shows an insulated trunk divider for the '67 - '69 Barracudas. The site recommends installation with the insulating material facing toward the seat back, thus perhaps providing advice to...