Recent content by intimidator

  1. intimidator

    Pics of early Barracudas

    2016 Mopar Max Sunday Winner
  2. intimidator

    Pics of early Barracudas

    Here is my A Body A motor car.
  3. intimidator

    Who Is From Iowa Here

    Looking forward t this race again this year. Hope I can finish as well as I did last year. See you there Toolmanmike.
  4. intimidator

    valve cover gaskets

    I have similar ones on my 340 that came in gasket set from Mopar a few years back. I have been using these on my race car 340 and have had them on and off many times and they do not leak. Do not have to use any sealant either!!
  5. intimidator

    How fast do you think it will run?

    15:20's at the best. To tall of a gear so it will spin a lot. Need to put in some 3:91's to with lock-up differential to get it moving. Also should bump the convertor up to say 2800 to get some good from the cam and intake.
  6. intimidator

    Post your 10 second combo

    Here is my motor setup. 1970 340 block 2 bolt main, Block rock filled on lower half of block, 20 over bore, J & E flat top pistons, Total seal gap less top ring rings, Eagle H beam stock length rods. I used the 3.79 stroker forged steel crank from Mopar. To get the compression up we installed...
  7. intimidator

    273 Build

    Radar and Woody do some real nice work.
  8. intimidator

    Who Is From Iowa Here

    Good Luck! Have fun and play safe!! Ed
  9. intimidator

    Who Is From Iowa Here

    Hi Tom Welcome! How you getting along since your accident? Did you make it to Monster Mopar Weekend? Ed Fox
  10. intimidator

    cam shaft selection

    A few years back we took a 318 and put it in a 70 dart. We used a stock grind cam from a 1970 Dodge 340 motor. This cam gave it some lope plus it gave it a lot of performance. We had a Holley 500 2 barrel carb on it and it ran in the high 14's in the 1/4 mile.
  11. intimidator

    what engine do i have

    They also had a tall block 383 back then that came in trucks. Check the distributor length.
  12. intimidator

    340 to 392

    Got as much torque as Horsepower. Don't need RPM to go fast. This motor was built to live. We set the piston out of the hole 18 thousands to get Compression. The heads are the key to the combination. big valve and lots of flow at 6000 rpm. Also the right center line cam helps to make the torque...
  13. intimidator

    340 to 392

    My flat top piston, 13:1 compression, 3.79 stroke, 571 lift cam, 950 HP Holley Carb, 20 over 340 block in a 3500LB Barracuda goes 10:80's shifting at 5800 and going through traps at 6500. 3.79 strokers rule!
  14. intimidator

    a little wager.....backfiring

    I'm with Yellowdart Dave and Fastback 340 on this one
  15. intimidator

    a little wager.....backfiring

    I'm with Yellowdartdave and Fastback 340 on this one
Back
Top