Just to be clear BrianT, I bought the Trans Dapt mounts that you pictured. exact ones. but the driver side is too big by about 1/4 inch. this is the second set that I have purchased from summit racing that dont fit. So when I was browsing the internet I saw someone with the same issue (I posted...
BrianT,
These are the mounts that I currently have and the driver side is off by about a 1/4 inch??? so this is why I was asking if I can just use washers as spacers to fill the gap to complete the install of the motor.
If anything I do have a V8 k mamber that I can put in, just trying...
Hey all,
Im have a 71 dart with the inline 6. Im putting in the 318 while still using the inline 6 k member. passenger mount installed fine. driver side one has a gap and there is a picture I found with the same thing and they just added washers as spacers to fill the gap. is this ok will...
Thank you DIYMIRAGE for this info.
Do they make a drive shaft that I can buy and install or do I have to have it cut and balanced.
Another question I have is, do I have to change out the rear end or can I keep the one that is there with the new 318 motor?
OMG I appologize FABO members I meant to say that this is the origional inline 6 in the car now NOT the 273. Do I need to get a longer/shorter drive shaft to connect tranny to rearend?
I am getting close to putting in the new 318 engine and I have a torqueflite 727 transmission (long shaft). My question is, do I need to get a longer/shorter drive shaft to connect tranny to rearend? Any and all help welcomed :)
Thanks FABO members.
Hey mrhollywood your engine is looking good man. I read that you plan on adding a turbo to your L6 and I was looking at doing the same thing to mine. You should let me know how it turns out and what all you had to get to do it. I hear that its not all that hard. I have never turbo'd anything so...
Hey all,
Im looking to see if anyone has any parts for the 1920 holley carb. Spacifically I need to get the side box that covers where the float goes. Or if I can get the whole carb that would work too.
Thanks
Hey all, my name is Chris and I just recently purchased a 71 dart swinger that Im looking to put a bigger motor in it and burn some rubber Lol. It currently has the slant 6 in it. The day after I bought the car I found a great deal on a 318 engine 727 trany and K member. So I got what i needed...