Recent content by Landon

I run 93 octane fuel. I did a little more checking on my timing marks at top dead center and they seem accurate. So I went ahead and double checked my timing and this is with mechanical only! No vaccum advanced hooked up! It read 12 initial and 42 total. Its always ran good at that and I've...

Ok so I'm trying to dial in optimum ignition timing for my 340 setup, 9.5:1 compression, 360 j heads, 2.02, 1.60 valves, comp 268xe cam, edelbrock rpm intake, 670 holley, 6al mad and Mopar perf distributor. I recently had a little trouble out of my vaccum advance and while diagnosing it I...

Tja Thats good to know! And no this will be my first time going.

Thanks!

Are any of you guys going to Mopars At The Beach next week in Myrtle Beach? I'm going to be taking my recently finished 76 Duster!

Is there a company that produces a clear side marker light lense for a 73-76 duster? I think it would be a clean look to have all clear marker light lenses with just the bulbs being amber and red.

They are factory

Any help would be greatly appreciated!

I'm trying to install the 3 point seat belts back into my 76 duster but I don't quite understand how the rear retractor mounts behind the rear door panel. Could anyone possibly take a picture of the rear retractor installed so I can get in my mind how it mounts along with the plastic cover. Thanks

Lol thanks! I still have a little tweaking to do to it before I want to really get on it. Also after having it out side to where I could stand back and look at it I thought it was a little too high in the rear so I put my 2in drop blocks back in the rear and lowered the front end slightly more...

Plymouth Duster First Drive: https://youtu.be/Ot92wLndlmQ 340 Duster First Drive: https://youtu.be/jmKMA3ON3So First time driving my duster in 5 years! This is the first time it's moved under its own power since I bought it and then began tearing it apart for a complete restoration. There...

On my 76 duster the amp gauge curcuit was incorporated in with the curcuit boarder on the back of the gauge cluster which at some time shorted and burnt a bit of the panel. I plan on bypassing it when I put it back together because I have lots of electrical add ons that would probably peg the...

Thanks man! The pics don't do it justice.

I'm 22 and this is my 76 duster. I bought it when i was 17, from a young gun who had it featured in the December 2007 mopar muscle issue. I drove it a week and started tearing it down. I've slowly been restoring it into a completely new car over the past 5 years and it's now close to being on...