Recent content by lawndart360

After the last mowing of the season, I had to pull my ATV Plow out of the garage which I normally kept in front of the mower. In moving it, I found a broken weld on one of the support straps. Looking closer I found that the weld looked nice, but there was absolutely no weld penetration to the...

I used a 94 van as a doner vehicle for my drivetrain swap. I found the speedometer was driven off the ring gear in the rear differential, I think you will probfind a bad pick up on the diff, the one for my Dakota cost about $29 and was a simple swap.

Still working..........

I paid $100.00 for all 5 windows, took him about 25 mins to do the back window with 1 sheet of material. He wasnt the slightest bit intimidated about it, if they are afraid, then I would go elsewhere. Professional tinter doing it on the side, otherwise would be about $300.00.

I also used the magnum exhaust manifolds, pass side was no problem at all. The driver's side was close, but helped by shaving the engine side about .040" at an angle and slightly massaging the area closest to the steering gearbox and then the same area of the gear box itself. I then cut up the...

My swap is probably a little more involved than the typical swap. I removed the entire wiring harness as well as everything attached to it from the 1994 Van and transplanted it into the dart, to include wiper switch, ignition switch, fan controls, fuel pump circuit, etc. The car is together...

Here is my Magnum setup with matching Magnum exhaust manifolds and A-518, including fuel injection, fits under the hood quite nicely I should add that I also have the low profile "hat " that feeds the remote air filter. The loose wires are part of the lighting harness and have sincebeen...

I lost a lot of my earlier pictures due to a computer crash. Very clean car that was disassembled to absolutely nothing. Only metal work was hand formed lower quarters about 3" inches high behind the wheels. 8 3/4 rear with 3.91 gears. US CarTool's laser cut subframe connectors, mid 90's magnum...

He was about 2 1/2 in the picture. I stopped by church to say a quick hello to the wife and kids. As usual, Holden wanted to jump in the car and turn the lights on. As I stood there for a moment, imaging my surprise when all of sudden, the car roared to life! Ignition interlock and additional...

In some ways, I have made a ton of progress, in others, I have a loooong way to go! As life happens, sometimes the hobbies have to take a back seat, with any luck, should be some photos attached.

I intend to start my own thread, 70 dart with a '94 magnum V8 and 46RE trans, complete harness thansplant from headlight to tail light, even using the donar vehicle guages, no cutting whatsoever in the harness. Having said that, there have been a mountain of obstacles, but what I keep seeing...

Welcome!!!

I'm a 15 year veteran police officer, currently assigned as a shift commander and fleet manager. In addition to the officers I work with, I also oversee a small fleet of late model chargers, with a few Ford and Chevy products sprinkled in as well.

The large, square-cut, o rings on oil fiilters. Each time I change one, I hold onto the o ring from the old filter thinking someday I may need one just that size. Well now I have proabaly 100 of them and have yet to have a need for 'em......

I'm going, have gone for the last several years. 2 hour drive each way but well worth it. In fact, it spoils my interest in any other show because nothing I go to can compare.