Recent content by Pitmoco

Someone didn't get the memo. 1968 Barracuda

All good. Thanks for the info, I have had it running for a month or so now. Fired right up and didn't even have a crossed plug wire, :). I pulled the head off with the manifold attached. Changed springs, valve seals and pushrods on both heads. Used 50ft of weed eater wire and a grease gun tube...

This makes sense. Will have to give this a try. Thanks

pics of driver and passenger sides \

4wd. Just seemed odd. Drivers side looks to be about 6" from frame. Passenger is about 1".

I had started tearing the top of the motor down and went to remove the exhaust manifold on the passenger side. Are they suppose to be tight against the frame? Seems impossible to remove the lower bolts without jacking the motor up.

107,986

Thanks for the offer rmchrgr, if I am going to rebuild heads, might as well be the ones I have. Joe The oil was clean when I bought it, I did change oil and filter anyway. Put new champions and coils in it before I found the broken spring. My budget is busted as is, I had bought a set of caged...

Thanks, as of now I am planning on pulling that head and replacing the exhaust valve, new seals, springs and retainers on both heads. Pull the pan and look for the keeper.

To start off, I am looking for help from you guys to get my truck back on the road. I have posted about this in a couple Dodge truck sites also. But FABO is far better then any other site. I have an 03 5.7 hemi 2500. 209k on the clock. I pulled into work a while back and it sounded like a...

Looks Good!

Excellent start!

Thanks, I was over thinking it, 41ring 10pinion, 4.10 it is.

Need help verifying that these are 8.25 4.10..... have been searching and can't find these numbers. Thanks Lee

pm sent