Recent content by Ricki01

Thank you

I’ve got a 97 dodge 1500 Just replaced all hoses thermostat and heater core. When I put the heater core in I bent the side of it. Would this cause it not to have heat now? It didn’t have heat before either. The blend door and heater motor are working. I’ve also burped the system. Any help...

Just wanted to Thank everyone that replied to my previous posts. I finally put the transmission back together and back in the truck. I’m ashamed of what the problem was but chalk it up as a hard learned lesson. The round ring that holds the sun gear in was not completely in . I took a...

It’s not a real hard thump. I can hear it work. I will disassemble the front clutch tomorrow. Was just trying to avoid redoing it all again. I replaced all the servos. Doesn’t mean they’re good does it? Thank you for your help

Sorry I thought I had Thank you for your help

I have not .

I did readjust the band and air tested it appears to be working fine. Spring is on the correct side. I did install a new torque converter. The lip seal in the direct drive?? Thank you for your help.

I’m still hoping to figure this thing out 1997 4x4 5.9 with 46RE transmission Well I have taken the overdrive back off and taken the valve body off. I air tested it and the bands all work and you can hear the clutches engage also I took the valve body apart and all check balls were in place. I...

Thank you I’m actually going to get back into it tomorrow. I’ll let you know what I find

Thank you I’ll check it when I put it back together again

Yes to all. I did disassemble the valve body. I replaced all the seals and rings Also checked clearances.I’ve taken valve body out again. I also took the overdrive off. Going to check these things again.

I did replace all the clutches. Replaced all the servos. Took all the spool valves out and cleaned them and valve body.

Good Morning I have a 1997 Dodge 1500 4x4 5.9 with the 47RE transmission I recently put all new clutches bands new pump torque converter and electronics in the transmission. Problem I’m having is it will not pull in reverse. It acts like it goes into gear but it just slips won’t move. All...

Good Evening Thanks for letting me join the site. Currently working on. 97 Dodge 1500 4x4 Have a tech question for the transmission gurus of the site. Look Forward to meeting and seeing all of the beautiful Mopars on this site