Recent content by smackhonda

If you get a chance could you send a picture tomorrow , Id appreciate it. Thanks

Well it just doesnt look right to me inside the window jam area and where the headliner comes down...I feel like its missing something. Here are a couple of pics but they are not very good.

I have a 68 dodge dart 2 door post. Im finally putting the interior together and I think Im missing a cover or some trim that goes around the rear quarter window and maybe on the post between the front and rear side windows. I cant find any pictures of whats suppose to go there. If any one has...

thanks

did you ever find a place to get those platic bolts? im looking for them too

i bought a disc brake conversion kit with the smaller brake booster in it. it came from aardvark

Thanks boden. That's pretty helpful. I talked with dave webber yesterday. He gave some helpful advise too. Getting closer to figure in this out.

Your looking for the kickdown linkages. Are you running a small block? You should be able to find those at a junk yard cheap. Maybe even ebay. Ill look i might even have that laying around some where

That's not the problems. I have power going where it should during cranking and the run position. I have a noid light in one of the plugs 4 the injectors. I've tested the power several times and I got power to the injectors during cranking and the run position. the computer is just not...

I went through my wireing and tested alot on my computer tonight. I have power going everywhere there is suppose to be power, and grounds everywhere there is suppose to be grounds, on run and start mode. I have a signal from my crank and a signal from my cam. Getting oil pressure signal. The...

I dont know if there is much difference, but my engine is out of a 06 jeep gc. I had to notch a corner on the head and valve cover on the L side rear. It wont clear the steer column. I had to notch for the alternator in the fender well. I cut out part of the K-frame and boxed it in for the oil...

Thanks boden, when I get home from work I'm going to try a few things. Its my goal to get this running right this winter so I can get the car to paint this spring.

here are a couple of pics of my 5.7 hemi in my 68 dart Just wish i could get it running. Every single detail of getting this motor in this car has faught me. It will be well worth it when im done but lots of modifications to make it work.

Also how would I be able to tell if the pcm is skim enabled? I seen on one of your post on the hemi swap thread a chart on the harness johnsparts. It list a brake switch. Does a brake switch have to be wired into the pcm to make it run? This harness I bought from plum floored doesnt have...

I got the harness from plumfloored creations along with the pcm. Ive had nothing but troubles from this company. Worst experience ever!!! It took a year to get all my parts after I paid for them. and some of the parts are wrong. Its impossible to get a hold of any one there. A lot of the plugs...