Recent content by SSG_Karg

Absolutely incredible. That’s what it’s all about right there.

What do you reckon this is? Kinda looks like a chunk of concrete to me.

“Not for sale. Gonna fix it up someday.”

:popcorn:

Sorry but it’s actually a 72. I just posted it here because it looks so much like the one @badlilred79 posted. It runs ok. Best so far of 11.98@116mph. Hope to whittle it down to low 11’s next summer.

27 years. My first car. Drove it to high school, my wedding day, and every chance I get.

Wow! Twinsies! Lol.

I’d like to see one in a Jeep CJ5. Wheelies!

I did exactly that a few years ago. I milled .050” off the deck surface and .040” off the intake side. It reduced the chamber from 67cc to 57cc. They had 2.02”/1.60” stainless valves installed and it raised my compression ratio a full point. I was still running stock replacement pistons that...

I run the Speedmaster fluid damper on my 422 stroker. Took it to the machine shop when I had the rotating assembly balanced and they honed it to fit the aftermarket crank. Because of the thickness, I ended up using the earlier small block (‘69 - back) crank and water pump pulleys and it’s a...

:)

I run the Milodon unit in my 422 stroker with a Melling HV pump in my street car. Spin it to 6500 often. It only has around 500 miles on it but I already replaced the gear as it was showing more wear than I was comfortable with. Replaced it with an old CAT gear recently. The shaft showed no...

340 block bored .060” 4” stroke forged crank 422ci. 10.53:1 comp. W2 heads 2.08/1.60 flow 266@28” Ductile iron rockers Howards solid roller .600” lift 245/253 108lsa installed at 104icl. Johnson lifters Racetec forged 23cc dished pistons, zero decked 6.125 Callies Compstar rods Mopar dual...

I like the idea of the over-the-tire straps but my trailer doesn’t have attaching points in those locations. May need to add some. Wood deck trailer.

Yep.