Recent content by stevndar

What is the distance between the mounting studs on the back and is one higher than the other?

I can't find this emblem at any of the classic car parts suppliers. The trunk emblem studs are 5 3/8" apart and the right stud is about 1/2" higher than the left.

My cousin had several balancers and we found the correct one for 340. Thanks for all helpful comments. She runs fine. :blob:

Thanks everyone. I thought it appeared to be a 360 balancer. Crank is forged, see photo.

Thanks Ken, I guess I'll be searching for a balancer.

In my '69 Dart, 340 ('71), 4 speed I have vibration at about 2000 RPM sitting still and I think I may have an incorrect balancer. I'm wandering if the previous owner may have installed the wrong one. I rebuilt with same pistons and crank (forged). Can someone show me a picture, diagram or...

Thanks again, haven't had a chance to check these out yet as I've been spending most of my time trying to get my '69 Swinger assembled.

Thanks much, I'll check out both suggestions.

Original drum on all four.

Anyone know how to correct extremely sensitive power brakes? Especially the 1st time applied it about throws you through the windshield. Then from there on they are still very touchy. Thanks for any advice you can offer.

Do you still have these? I am going to Englewood in March and may be interested.

Does anyone know the overall length of the front brake cable on a '69 Swinger? I bought a 3 piece cable set from The Right Stuff and the front cable is too short to reach the rear bracket where the two rear cables connect. Their tech told me I have the correct one. Also if anyone has pictures of...

I hope the attachment attached itself.