Recent content by valianator

message sent.

what would it cost to ship it to Poseyville, IN (47633)? Thanks

Sounds good to me! Lemme know if you have a Paypal account or I can send you a money order. I'll PM you my address. Thanks.

I'll buy the pump. How much to ship it to 47633 (Poseyville, IN)? Thanks

I just wanted to thank all those who responded to my wanted ad for a B body front hub. I didn't know I couldn't add a thank you message after I marked the ad "sold". Thanks, FABO! :thumblef:

OK, thanks- With the hub sitting inner bearing side down on a flat surface, it measure 2 and 5/16 inches from the surface it's sitting on to the machined flat surface around the studs. If you turn the hub over, outer bearing side down, it measures 2 and 7/16 inches from the surface it's...

I have a set of B-body 10" drums swapped onto my 65 Valiant (with 73-76 UCAs). I started hearing a god-awful racket from my left front wheel, took it apart to find the outer bearing race spinning loose in the "wallered out" hub casting. I just put new bearings in few months back... don't...

Can a 5.2 Magnum crank, rods, and pistons be used in an older 318 LA block? Was thinking this would be a cheap way to bump up compression in a 318. I think I remember reading something about the rear main seal being different, though- one piece on Magnums? Can the Magnum type seal be adapted...

My axle has gone from whining to sounding like a coffee can full o' rocks. I've ruled out wheel (outer axle) bearings and the fluid is full.:( So I'm needin' a BBP 7 1/4, with 2.76 or 2.94 gears. Within ~200 miles of Evansville, IN. (I'll pick up.) I can spend mabey up to $150 or so. Or...

I always thought the 340 should a been an option "across the board" for A-bodies, like the Hemi in the 66 (and later if ya knew who to ask) B-bodies. I bet Chrysler would have built you (for instance) a 340 4-speed Valiant 100 2 door sedan if you knew who to talk to and were willing to pay up...

I remember seeing '74-'76 Dart SE's and Valiant Broughams with a separate center armrest between buckets. Were there any others in A bodies?

Hello, Do you have an accelerator pedal assembly? I would need it shipped to 47633. Thanks!

"Turn your plain '63-'66 Valiant or Barracuda into V-8 4-speed car with all the de-luxe interior and exterior trim goodies for $1500!" Don't sound too bad if ya put it that way...:D

Something I've never seen, but would be handy, is a list of all the steelies that came on torsion-bar era Mopes. The Rallyes and Magnums have been pretty well covered by the magazines over the years- I'm talkin' about the standard steelies intended for hubcaps or wheelcovers. I know SBP A body...

This gets my vote for ugliest Mopar ever. A rolling exhibit of everything that went wrong with car design in the last ~25 years. Say what you will about the '05 Charger sedan not being worthy of the Charger name; it's a HUGE improvement over these road lice.