[SOLD] Small block 833 Lakewood Scattershield and Block Plate

-
Status
Not open for further replies.
S

Swingin1970

Well-Known Member
Joined
Jan 4, 2018
Messages
345
Reaction score
164
Location
Santa Barbara CA
Rating - 100%
6   0   0
Contact seller
Small Block Lakewood scattershield for 833 trans complete with block plate and all brand new hardware. Both Block Plate and Bell have been professionally powder coated semi gloss black. Brand new hardware and Fork included. These are getting very hard to come by these days. Asking $500.00 plus shipping. PayPal accepted.

IMG_0980.jpg


IMG_0981.jpg


IMG_0982.jpg
 
Last edited:
Crossrammed340 said:
Is this set up a direct replacement for the OE housing and special shims or adapter rings needed.
Click to expand...
The seller is correct but you have to make sure the bell is perfectly centered for the transmission to be perfectly aligned to avoid vibrations. Even a stock bell that did not come with the engine/trans set up should be checked and adjusted. Off set downs are used to correct alignment. There is an adapter ring for the small bearing retainer. It is not truly needed. Helpful, not truly needed.

Lakewood has instructions that can be downloaded and followed. To type out the instructions is lengthy or really easy to speak about but the actual work takes time and it can be tedious to summer. It’s actually not difficult, just time consuming. Accuracy is everything. That’s what makes the job a pain in the ***. Otherwise, it’s really not hard to do.

In my opinion, this is an excellent set up at a good price.

To the OP, GLWS
 
Status
Not open for further replies.
-

Back
Top