273 Commando - UTG

-
There's scuttlebutt that he bought his subs. YT apparently is looking into people who have fake bought subs. But I'm not 100% on that its hearsay. If you Google "buy yt subs " links will pop up...Uncle Tony is a clown though his recent video a guy drives 3/4 way across the country to race him and his car never leaves the line...something broke, how convenient but I say only a total nincompoop drives 5000 miles round trip to not even race...and Uncle Tony's fans say in the comments " oh it was great you guys did good" yada yada yada...Uncle Tonys drag race videos are way too predictable if you ask me...its just him in his POS Valiant doing a burnout and going Sssslllllooooooowwwwww ...:thumbsup:
 
I thought the video was inaccurate and biased. But I have to make a comment about the 7.25 rear end reliability.

It’s been nearly 58 years since I bought my ‘65 GoGo in September of 1966. I can’t recall the mileage on it, but it was low, probably less than 7,000 miles. I beat the hell out of that car, racing it at the strip and on the street (mostly.) My first set of tires lasted 6,000 miles - and I didn’t rotate them. The stock Auburn clutch ( a three-spring design, as I recall) didn’t last very long, so I replaced it with a clutch from a local rebuilder that was sort of a “poor man’s Sheifer.”) That clutch was much stiffer, and I beat the pedal so hard, that the pedal assembly cracked the firewall at the mount, forcing me to weld it up. Somewhere I picked up a set of SBP 14” wheels with recapped “cheater slicks” that I used for the strip and selected street events. I read every article I could find on tuning and hopping up the 273. The two most helpful were one on jetting the AFB, and setting up the distributor, which I did on the Sun distributor machine in the very well-equipped auto shop at NW Classen. My final mod was a “dump” pipe I welded in just past the “Y” in the exhaust pipe. Running 104 octane DX Super Boron (Sunoco 260 in other areas) I could break into the high 14’s at the local stip in OKC (I believe it was called Sun Valley.) The standard limited-slip never missed a beat until I sold the car the following summer to help pay for my college tuition. It had a little over 16,000 miles on it, and was on its’ third set of tires. The little 7.25 never failed to leave two dark strips on the asphalt with either slicks or street tires. It was also very quick off the line, which won a lot of races on the street.

As for this guy’s. love for Mustangs and Camaros, I owned a ‘65 Mustang 225hp 289 four-speed a few years after that, as well as a ‘67 Camaro with a very built 350. My Dart out-handled and out-stopped both of them, and I thought it was a better car overall, not to mention having a back seat large enough for recreational purposes. It was also quicker and faster than my Mustang, and I beat a bunch of stock 289’s on the street with my Dart. I was looking for a Formula S Barracuda when I bought my car, and didn’t even know a Dart GoGo existed until I saw mine on a used car lot across the street from my high school. I did know about the 235hp 273, and it was love at first sight when I raised the hood and saw that beautiful motor. The Hurst Competition Plus was icing on the cake, as was the yellow paint, gorgeous black interior, and, just like the Formula S, rally stripes. It even had a small RAC tach mounted on the dash.

Just my two cent’s worth.
Are the 14 inch cheater slicks for sale?
 
from toolman's post #11 of towing package elements - "high output alternator 46 amps"....
 
How does he have 364,000 subscribers???????
I did so I could Mark his channel. But later un-did-it.
Was told he was at Lowe's or Home Depot on the plumbing isle buying fuel line.
Saying the toilet supply was the same as SS AN fittings and hose.
And the vid where he made some kid a 318.that blew up talked about here.
It's your guys fault I looked at his site.
Bad influence! There I said it You guys are a bad influence.
Just look at this site. A new guy asks how do I tune up my 3182bbl. Put in a 360.
 
Last edited:
FABO tune ya 318 to perform by putting a 360 mag in.
UTG tune a 318 by putting a used carb off a junk motor on it. And 8 used spark plugs from lawn mowers he found on the road side. He did rebuild the plugs by sprain them with dollar store something or other.
Rewire with Romex since it makes solid copper core race wires. From construction site trash piles.
Ok not real UTG episode but close.
Damm hope he don't read this, he might get an idea for a new episode.
 
There's scuttlebutt that he bought his subs. YT apparently is looking into people who have fake bought subs. But I'm not 100% on that its hearsay. If you Google "buy yt subs " links will pop up...Uncle Tony is a clown though his recent video a guy drives 3/4 way across the country to race him and his car never leaves the line...something broke, how convenient but I say only a total nincompoop drives 5000 miles round trip to not even race...and Uncle Tony's fans say in the comments " oh it was great you guys did good" yada yada yada...Uncle Tonys drag race videos are way too predictable if you ask me...its just him in his POS Valiant doing a burnout and going Sssslllllooooooowwwwww ...:thumbsup:
The only Uncle Tony video i watched was the one where he was talking about A.body rear ends. It surprised me because he is the only person I've ever heard saying anything positive about the 7 1/4" rear end. He called it a "downsized Dana60" and said "in a car less than 3300lbs and 300hp these things are "fantastic." All I can say is after my experience with one in a stock 273/904 car driven gently that sure wasn't true for me. I'm so glad I just decided to chase down a factory 8 3/4" rear. Now I won't have to worry about it again.
 
The only Uncle Tony video i watched was the one where he was talking about A.body rear ends. It surprised me because he is the only person I've ever heard saying anything positive about the 7 1/4" rear end. He called it a "downsized Dana60" and said "in a car less than 3300lbs and 300hp these things are "fantastic." All I can say is after my experience with one in a stock 273/904 car driven gently that sure wasn't true for me. I'm so glad I just decided to chase down a factory 8 3/4" rear. Now I won't have to worry about it again.
Uncle Tony cars are always junk that speaks wonders for him actually. I am to the point where its like "Tony who? oh that guy what's he up to ? same old? ok..." :)
 
UT Seems to burn anyone that works with him, and never finishes anything. Richard Ehrenberg used to slag him in M.A. I’m a subscriber, just so I can dislike his videos…
 
-
Back
Top