Search results for query: *

Oh well..really surprised no one didn't kick the crap out of Bennett..they're are certainly NOT the big bad Bruins I grew up with!!

I'd remove the roll bar. Roll bars are for sissy's and you might as well get rid of the seat belts too. Lighten that car up!

I have a 42RH in my dart that shifts OD and lockup fully automatically by using pressure switches off the governor port of the trans. The switches are even adjustable so you can set your preferred shift speeds. Or turn both off to simulate a standard 904. Same can be done with the 46RH and...

Bump

100% pay back...

Welcome from West Virginia...........................:thumbsup: Lets see some pics of the Dart.

Looks close to size of tomato paste can

Unfortunately almost 5 hours away from me...........................

Well done! IMHO, LEGENDARY is not Legendary. You made a great choice. :thumbsup:

Well....The roll bar requires a big hole. slice it and adjust to the size you need. Cutting a round hole is hard with a knife

Glade to be here. I love a body's. I have a 67 dart 273 with 3 on the tree. I am also looking to purchase a 64 barracuda 273 4 speed car. I have found one but am confused about the finder tag. Not sure if this is were I should be asking questions, but here I go. Most everything on the tag...

CCA has the bracket kits for the cast water pump as well as the aluminum. It was one of the questions they asked.

or fender lip plastic trim...............

Bet fender welting would work to wrap around the roll bar cuts.

I am going to have to slice to enclose them like he did originally....................... I need to take my time with it. I am gone all next week then only a couple of days load up to go to MITP, if I don't get the carpet in no big deal.

and how old is that car ??

Entry fees are higher than a cats back! It's been a long time since I went to a dragstrip regularly.....are entry fees that high everywhere?

Big holes!

Heat up an empty soup can to make circle cuts

^ That helps a lot! It sounds like melted or chaffed (bared) wires from the engine harness bulkhead on the inside of the car. Look at the wires where the bulkhead connector enters the interior through the firewall. If you have an ammeter also make sure the connections are good there and it's...

Is that in the living room? :D

Make a paper template

I have to figure out with the roll bar as well.....................

I always make the cuts longer than really needed. Sucks when you make one short there is no going back! Brand new mat knife blades are a must for me.

It's Sebring Saturday! Good morning :D

Plenty of those.................:thumbsup:

How about an old knife

I was gonna use an awl and a torch.... think i'll try my soldering iron first now :)

I'll offer $150 for them

Here is the 727 transmission is 1972