Search results for query: *

Is it a cast aluminum piece?

https://www.oreillyauto.com/detail/c/dorman-help/dorman-help-distributor-gear/mtm0/90450 Special order here, maybe available there?

didn't Dorman or whatever came in the red packages ( Help! ) have them at the parts stores...decades ago?

yes, and a boot is a deck lid

HA! look at that shipping price! It's gotta be at least $35 now. What brand is the flywheel?

sent pictures but I have the model with the braces. Sorry. Bob

are these A-body with the small ball joints, K-H disc and drum brakes? I have a pair that were bought new, never installed BUT ball joints and UCA bushings were installed. Also, they are black and not a cosmoline finish. If these sound like what you need, I'll get pictures tomorrow. I just...

is this the $300 e-bay bracket you are looking for a template for? PM your address and I'll get a tracing of it off to you. Bob

replied to message, here are the pictures.

I guess early ones have three pins, although they appear to be in locations used by the four pin model. Only the flower is lacking a pin on mine.

got a new three pin version with the plastic inserts

not mine, but just saw this one: https://rockford.craigslist.org/cto/d/algonquin-1972-dodge-demon/7284841225.html

I "THINK" Hooker made them way back when and I called to ask about them. They"CAN", but...either it was an order for so many or huge dollars to make one set. Look up Tubular Automotive on the east coast, maybe they still list them. Got a new set of under chassis JR headers...small tubes though.

you COULD make a 70-up 2-dr. sedan... start with a 4 door, add 2-door sedan doors and front half of the 1/4 panel. TA-DA!

same place I would be...ideas but not ability or tools to do.

could you use the V8 brackets, cut and splice them to fit? Cut above where it bolts to the k-frame and use flat plate to make up the difference/spacing?

may have a pair coming from WI, will keep you posted.

I saw that also. Did not know they had them in different spots. Thank-you for educating us! Bob

yes, the sockets (better name than what I called it). Clips not needed.

I'll say yes if they are for an A-body.

looking for the cylinder the t-bars slide thru in the rear and not the whole cross member

replied

this is the "sleeve" that holds the rear of the torsion bar to the crossmember. It also has the retainer clip and boot attaching points. If you've replaced your rusty crossmemeber and have these left over, give me a shout! Thanks! Bob

small or large ball joint?

doesn't the Edelbrock Magnum engine have the offset thermostat?

Professional Products 55026: Crosswind Intake Manifold 1500-6500 RPM Range | JEGS

automatic or manual transmission shift? I have auto version.

68 to 72 or 73 and up?

Kevko has plates that replace the bottom of the oil pump but has a pick-up already attached.

sending PM