Search results for query: *

Okay thanks, I'll pass.

What about the lining material between the body of the joint and the ball, any idea?

Ken, what is the lining between the inner and outer parts of the joints and are the nuts locking nuts, because I see the dimples on them.

Those are most likely for a solid lifter small block, the pushrods for a hydraulic small block measure approximately 7 1/4".

@Hyper_pak might find this interesting.

What is the SFI date on the balancer?

Single or double groove pulley?

I didn't see a price for the throttle return bracket, I might be interested in it.

@340 RR

Thanks Al, I'll pass. I'm looking for a set of grooved shafts to put on a mid to high mileage 318.

Al, what kind of shape are the shafts in? I may be interested in everything but the push rods, I have 5-6 sets to put the set on a hydraulic cammed engine.

Photobucket sucks, it should not be used for anything. In addition, there are no date stamps on the pictures so no one knows how old they are.

Can you post some better and clearer pictures?

Yep, what you posted is unreadable to some of our "old" eyes.

Kim, I have this same "style" mc on my bracket car and it took a standard push rod.

Stan, whenever I see slant performance parts I always think of you.

@Hyper_pak maybe interested on some of these parts.

Which pan do the front and rear oil pan gaskets fit?

Which small block? The 360 has a different smile than some of the others.

Are you "sure" they are TTI headers? Post pictures of the PN if it is stamped on the headers. TTI made two different BBM headers, one set was for the B motor 361-383-400 and the other set was for 413-426-440 RB motor. The B motor headers will work on the RB motors, but the RB headers will hang...

It is a spread bore carburetor from the pictures.

@Ken71Twister maybe interested in this.

What would shipping be to 77328?

The pushrods pictured look to be for uncut or minimally cut heads with hydraulic or solid lifter cams.

BBM, or SBM?

What is the PN on it? It looks like it's for a 66 and later SBM.

If the lower neck is the OD same size as the water pump neck, it will work. The radiator I have (not Cold Case) has an angled lower neck on it, I just had to shorten my lower hose by 1/4" to take the slight kink out of it.

I've never seen any "factory" 273 rockers arms with jam nuts and my first 273 was acquired in 1966. Some one faced the top of the arms and added the jam nuts, Ed Hamburger used to sell them on exchange system I believe.

@Hyper_pak might have an interest in these.

The box says 7.425" length.