Search results for query: *

Bump

Bump

Now, they're $846 Summitt not available now If you think about it, how little demand there is for them

Fifty years ago, when my 65 Barracuda reached 100,000 miles or so, I had to learn mechanical skills because I got tired of my car running worse after service than when I took it in. I had to wean myself from my Dad's advice to "let the professionals work on it." I've made my share of mistakes...

Bump

Bump

Bump

Bump

Bump

Call Laysons also. @Rick@Laysons

Morning woke up to a ford letter word! Congrats Willie!

Street Dominator with a tuned Thermoquad is by far the most off idle responsive, best overall set up ever for me An earlier Quadrajet, made by Carter, highly tuned wasn't far behind

Bump

Bump

Bump

I have a 64 I was going to restore all torn apart right now slant car rebuilt engine etc For a roller or a resto. , want the room so with or without engine trans etc in central PA. Tons of new/used sheet metal also.

AJ,....Zat You??? :rofl:

Torker II didn't appear until '80's bro....& more resembled a Holley Street Dominator, which resembled a slightly lower Offy Port-O-Sonic, which is a bit lower than a Holley Strip Dominator......

I use a trigger wheel cut from the CAD diagram Subcom sent me. It cost me under $40 to have it made. I probably have the diagram if he can’t find it. I use an unmodified magnum distributor; cap and everything! I went with a 4150 style throttle body because I wanted to retain my carb hat and...

OMG! THAT! is The Coolest Car I have Ever Seen! So, Jealous! Searched for a 4-Speed 2nd Gen since 1994... settled on a 1st Gen after 30 years of looking.

Well phooey! I just invested almost an hour to read this whole thread only to find.......the OP hasn't been here for a year plus and doesn't look to be active any more. We will never find out what happened.

Find a noted cam grinder like Oregon I know of no negative feedback on them .they will grind a custom cam for your specific engine/power train. Will cost more than inexpensive ones, best of both worlds, best power available, quality. You don't want to be cheap on this

The 22 that were DQ'd are out of the same shop.

So I've been trying to find a Lunati 20200717 camshaft (213/219 hydraulic roller) for a long time. Finally Lunati reached back to me, telling me it is discontinued.

Hmm, that could be possible I'll check it out when I'm under there tomorrow

Nope

Not that I'm aware of. If that's the case I should hear it when I'm just just sitting there reving it I would think.

My pickle fork was taken by TSA airport security at preflight shakedown while traveling to work on my daughters Corvette. Dammit!. They let me keep my vacuum gauge.

Honestly I would direct the energy to finding a stronger rear end like an 8 3/4 . By the time you verify straitness and buy gears/ pay for the to be set up you are 3/4 the way to an 8.75 . Since you want 4.10s I have to assume you are making some power and plan on using that power . I...

Is it attached to a bag? If yes its han its a hose bag hose :rofl::rofl: