Search results for query: *

fyi, if you go different bell you'll need to modify your Z-bar and attachment hardware along with the clutch fork (or buy a new one).

www.moparmuscleofcentralpa.com/history-of-the-pentastar.html "It was placed on the passenger side fender so it could be viewed by passers-by, a subtle method of getting the symbol ingrained in the public's mind: a nameplate has to be read, but a symbol is quickly recognizable without reading...

The wheel bearings were replaced but so far the seller in not saying why.

That's nice!

How tall of a tire do you run?

That's a valid argument. Thanks for the point!

Sold! Thank you Scott and FABO!

I would rather have both a gauge and a light.

Any updates?

I would think it does. A friend has that exact car we have been working on, off & on for a few years now. I will try to find out for you exactly (Measurements) where Chrysler put them on the lower right fender if you'd like. Car was bought right here in Morrisville, Pa.& was mostly an original...

That has to be an inner wheel bearing failure. The seal rides further back on the shoulder, and the inner race should be seated against the lower section of that. That looks like where the roller for the wheel bearing would be, so maybe a roller backed out of the cage? Still problematic...

Have tried just as you suggested. No good.

Mine did have one on the right fender only. I remember seeing quite a few back in the day the same way. Right side only

Right side, one only, lower front fender dog leg.

So ,as in your case, if the pins were from a 73 as well as bracket the 70-72 caliper can be used. Thus my pins, as stated earlier, do not match the bracket so bracket is incorrect or the pins. Threads are not stripped. Have tried both good pins in brackets.

Sorry to read! Strength and +ve thoughts sent!:canada::usflag:

Attached bottom of both front fenders. Let the blocking begin. Over a gallon of high build primer. 320 grit. I need to do some research on how much to sand. The dart doors and fender have up to 5? flat plains to use to block. I am taking it down and when I see a dip or rise I stop in that area...

Here in North Georgia, Helene was slightly worse than the storm we had on Wednesday, maybe by 50% more rain and wind speed. Wasn't great to have them back to back, but most of the Atlanta area is ok except for a few spots of flooding and downed trees.

Please explain bottom bulb or top bulb in the simplest terms for my dumb *** to understand. I don't believe we have any of that stuff around here.

PM sent

After you check the threads. Take the calipers off and see if they will thread in there.

She was disabled and lived in St. Petersburg, not far from the beach. She only had a carport, so they weathered(rusted) pretty quickly. All her children and inlaws pitched in to buy her a new one every 2 to 3 years.

Realistically it probably doesn't make a difference. I like to have them in because it means the LCA torsion bar socket is going to be located exactly like it will be when the car is on the road. But it's pretty unlikely the torsion bar will move it much, because they won't slide in if they do...

Out of a 1970 A-body build in Ontario. Assembled Nov 18, 1969

…don't really wanna be standing on the roadside (assuming I'm still alive/conscious) looking at my damaged vehicle and going "I don't care what the government says", either.